Rotary Dampers
FRN-C2-L301

Flexible and cost efficient use

Continuous Rotation
Damping torque 3 +/- 0.8 Ncm

The damping direction of the simple FRT-C2 and FRN-C2 is either right, left or two-sided rotation. These ACE rotary dampers with plastic body can decelerate directly in the pivot point or linear through a gear and gear rack. ACE rotary dampers are maintenance-free and ready-to-install.
FRN-C2-L301
Continuous Rotation
FRN-C2-L301

Technical data

Damping torque 3 +/- 0.8 Ncm

Damping direction left

Gear without

Construction size Ø 15 mm

Rotational speed max. 50 rpm

Lifetime 50,000 cycles (1 cycle = 360° left-hand, 360° right-hand). Even after this time, the dampers still produce over approx. 80 % of their original damping moment. The service life may be significantly higher or lower, depending on the application.

Operating temperature range 0 °C to 50 °C

Pressure angle 20°

Material Outer body: plastic; Shaft: steel

Mounting in any position

Tooth Involute gearing

P.C.D. 8.8 mm

No. of teeth 11

Module 0.8

Mounting information

No axial or radial forces may be induced via the shaft.

Safety information

Do not use rotary dampers as supports. Provide an external guide or support.

On request

Special designs available on request. Toothed plastic racks (modules 0.5 to 1.0) are available for the rotary dampers with pinions.

General information
×

ACE Controls Inc. | Login

Already Registered? Login here.
For all first-time customers, an account is created when the first order is made.
If you have any questions please contact ebiz@ace-int.eu.